Wen 6501 Service Manual download pdf (Page 8)

Electrical information (continued)

Guidelines for using extension cords

WARNING: This tool is for indoor use only. Do not expose to rain or use in damp locations.

Make sure your extension cord is in good condition. When using an extension cord, be sure to use

one heavy enough to carry the current your product will draw. An undersized cord will cause a drop

in line voltage resulting in loss of power and overheating. The table below shows the correct size to

be used according to cord length and nameplate ampere rating. If in doubt, use the next heavier

gauge. The smaller the gauge number, the heavier the cord.

Minimum gauge for Extension Cords (AWG)

(When using 120V only)

Ampere Rating Total Length of Cord in feet

More Than Not More Than 25 50 100 150

0 6 18 16 16 14

6 10 18 16 14 12

10 12 16 16 14 12

12 16 14 12 Not Recommended

Be sure your extension cord is properly wired and in good condition. Always replace a damaged

extension cord or have it repaired by a qualified person before using it.

Protect your extension cords from sharp objects, excessive heat and damp or wet areas.

Use a separate electrical circuit for your tools. This circuit must not be less than a #12 wire and

should be protected with a 15 A time-delayed fuse. Before connecting the motor to the power line,

make sure the switch is in the OFF position and the electric current is rated the same as the current

stamped on the motor nameplate. Running at a lower voltage will damage the motor.

WARNING: This tool must be grounded while in use to protect the operator from electrical

shock.

Model: 6501 wenproducts.com

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

No comments

Wen 6501 Service Manual Page 8