Wen 6501 Service Manual download pdf (Page 10)

Assembly and adjustments

Feet Placement

1. Carefully set the Belt/Disc Sander on its side.

2. Press each Rubber Pad (28) over the lip of the Base at each corner.

(See Figure 1)

Mounting Aluminum Disc and installing a Sanding Disc

1. Use a screwdriver to loosen the 3 screws on the top side of outer

pulley cover. (Figure 2)

Figure 3

2. Align the 3 holes on the disc cover with the 3 holes on the outer

pulley cover, and fasten the disc cover on the outer pulley cover

by 3 screws. (Figure 3)

3. Place the Aluminum Disc on the drive shaft. Align the flat face

of the drive shaft with the set screw in the hub of the Aluminum

Disc. Fasten set screw with the Allen Wrench provided through

the hole on the top of the Disc cover. (Figure 4)

Model: 6501 wenproducts.com

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

No comments

Wen 6501 Service Manual Page 10