Assembly and adjustments Feet Placement 1. Carefully set the Belt/Disc Sander on its side. 2. Press each Rubber Pad (28) over the lip of the Base
Assembly and adjustments (continued) 4. Peel sanding disc adhesive backing. Align perimeter of new sanding disc over the Aluminum Disc and press fi
Assembly and adjustments (continued) Mounting table for use as Disc Sander NOTE: The Table (69) may be used as support for both horizontal and verti
Assembly and adjustments (continued) Mounting table for use as belt sander NOTE: The Table (69) may be used for both horizontal and vertical operati
Assembly and adjustments (continued) Mounting stop plate This Stop Plate (63) fits across the top of the sanding belt and is for preventing workpiec
Assembly and adjustments (continued) Install the sanding belt 1. Push the Belt Tension Handle (50) forward to loosen the belt. 2. Remove Upper Gu
Operation ON/OFF switch (Figure 13) The keyed switch is intended to prevent unauthorized use of the sander. WARNING: Remove the safety key whenev
Operation (continued) Sanding inside curves (Figure 15) Sanding the inside curve of the workpiece is done by positioning the workpiece on the idle
Maintenance WARNING: For your own safety, turn the switch OFF and remove the plug from the electrical outlet before adjusting or performing mainten
Exploded view Model: 6501 wenproducts.com 19
Table of Contents Technical data………………………………………………………………………. 2 General safety rules…………………………………………………………………. 3 Specific safety rules for belt
Parts list Item # Part # Description Qty Item # Part # Description Qty 1 6501-001 Screw M4 X 12 9 39 6501-039 Rubber Tube 1 2 6501-002
Model: 6501 wenproducts.com 21Warranty WEN Products warrants its power tools to be free of defects from materials and workmanship for a per
General safety rules Safety is a combination of common sense, staying alert, and knowing how your belt/disc sander works. SAVE THESE SAFETY INSTRUCT
General safety rules (continued) 13. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to OFF. Do not leave the tool until it has come to
Specific safety rules for belt/disc sanders WARNING: Do not operate this tool until it is completely assembled and installed according to the inst
Specific safety rules for belt/disc sanders (continued) 13. Do not sand with the workpiece unsupported. Support the workpiece with the backstop or t
Electrical information Grounding instructions IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides the path of least resistance for ele
Electrical information (continued) Guidelines for using extension cords WARNING: This tool is for indoor use only. Do not expose to rain or use i
Know Your Belt/Disc Sander Unpacking WARNING: To avoid injury from accidental starting, turn switch OFF and remove plug from power source outlet b
Comments to this Manuals