Wen 6501 Service Manual download pdf (Page 16)

Operation

ON/OFF switch (Figure 13)

The keyed switch is intended to prevent unauthorized use of the sander.

WARNING: Remove the safety key whenever the sander is not in use. Place the key in a

safe place and out of the reach of children.

1. To turn sander ON, insert the safety key into the

key slot in the center of the switch.

2. Push key firmly into the slot, then push switch to

the ON position to start the sander.

3. To turn the sander OFF push switch to the OFF

position.

4. Remove the safety key when the sander has come

to a complete stop by gently pulling it forward

and out.

Surface or edge sanding on sanding belt

(Figure 14)

Hold the workpiece firmly with both hands. Keep

fingers away from sanding belt. Keep the workpiece

end against the backstop and move it slowly across the

sanding belt. Apply enough pressure to remove

material; excessive pressure will reduce sanding

efficiency.

Model: 6501 wenproducts.com

1 2 ... 11 12 13 14 15 16 17 18 19 20 21

No comments

Wen 6501 Service Manual Page 16