Wen 6501 Service Manual download pdf (Page 17)

Operation (continued)

Sanding inside curves (Figure 15)

Sanding the inside curve of the workpiece is done by

positioning the workpiece on the idler pulley of the sanding

belt. Hold workpiece firmly with both hands.

End sanding and outside curve sanding with the disc

(Figure 16)

Use for sanding the ends of small and narrow workpieces

and outside curved edges. Always work on the left side of

the disc (downward rotation side), holding the workpiece

firmly with light pressure against the sanding disc.

Note: Always maintain a maximum of 1/16” clearance

between the Table and sanding disc.

CAUTION: To avoid personal injury and/or damage to the workpiece, become familiar with the

rotation of the belt and disc sanding surfaces.

The belt sander rotates counterclockwise or downward toward the table or stop plate. The disc

sander rotates counterclockwise, downward toward the table on the left side of the disc and upward

from the table on the right side of the disc. Always use the left side of the disc; using the right side

of the disc will cause the workpiece to fly up or kickback and could result in injury. Review this

instruction manual for correct operation, adjustments, and basic sanding operations.

CAUTION: When finished with Belt/Disc Sander, to prevent accidents, turn off and disconnect its

power supply after use. Remove the safety Key from the Switch (31). Wipe down and store the

Sander indoors out of children’s reach.

Model: 6501 wenproducts.com

1 2 ... 12 13 14 15 16 17 18 19 20 21

No comments

Wen 6501 Service Manual Page 17