Wen 3912 Use and Care Manual

Assembly and adjustments Unpacking Carefully unpack the band saw and all its parts, and compare against the list below. Do not discard the carton

Assembly and adjustments (continued) WARNING:Unplug the machine from the power source before assembling or adjusting anything. Failure to comply may

Assembly and adjustments (continued) Figure 2 TrunnionFlange Bolt Stop Bolt Hex Bolts Table Installation (Figure 2) 1. Place the table on to the upp

Assembly and adjustments (continued) Rail Guide and Fence Installation (Figure 4 & 5) Attach the rail guide (Fig. 4) to the front of the table.

Assembly and adjustments (continued) Note: The blade teeth should face the operator and should point down towards the table. 9. Position the blade

Assembly and adjustments (continued) 1. Open the upper and lower doors. Rotate the wheel forward by hand, and observe the position of the blade on t

Assembly and adjustments (continued) If a blade is being replaced with a new one of a different size, the adjustment described above may fall out of

Operation Figure 11 ON/OFF Switch(Figure 11) 1. To turn the saw ON, move the switch to the up (ON) position. 2. To turn the saw OFF, move the swi

Operation (cont.) Cutting Curves When cutting curves, carefully turn the work piece so the blade follows without twisting. If the curve is so sharp

Exploded view and parts list (Band saw) 19

2

Exploded view and parts list (Band saw) Item# Stock# Description Item# Stock# Description 1 3912-101 Door Locking Knob 27 3912-127 Hex

Exploded view and parts list (Table assembly) 21

Exploded view and parts list (Table assembly) Item# Stock# Description Item# Stock# Description 1 3912-201 Tap Screw 23 3912-223 Bolt 2

Exploded view and parts list (Stand) Item# Stock# Description Item# Stock# Description 1 3912-301 Bolt M8x40 6 3912-306 Stand Leg 2 3

Limited two years warranty WEN Products is committed to build tools that are dependable for years. Our warranties are consistent with this commitment

Table of contents Technical data……………………………………………………….. 3 General safety rules………………………………………………….. 4 Specific safety rules for band saws………………………

General safety rules Safety is a combination of common sense, staying alert and knowing how your band saw works. SAVE THESE SAFETY INSTRUCTIONS.

General safety rules (continued) 13. NEVER LEAVE A RUNNING TOOL UNATTENDED. Turn the power switch to OFF. Do not leave the tool until it has come to

Specific safety rules for band saws 1. To avoid injury from unexpected movement, make sure the saw is on a firm, level surface and properly secure

Electrical information Grounding Instructions IN THE EVENT OF A MALFUNCTION OR BREAKDOWN, grounding provides the path of least resistance for elec

Electrical information (continued) WARNING: This saw is for indoor use only. Do not expose to rain or use in damp locations. Guidelines for Usi

Know your band saw 1 4 3 2 1 Blade tension adjusting knob 2 Ball bearing guide 3 Miter gauge 4 Switch 5 Locking fence 6 Metal stand 5 6 WAR