Wen 70712 Use and Care Manual download pdf (Page 4)

14. NEVER STAND ON A TOOL. Serious injury could result if the tool tips or is accidentally hit. DO NOT store

anything above or near the tool.

15. DO NOT OVERREACH. Keep proper footing and balance at all times. Wear oil-resistant rubber-soled foot-

wear. Keep the floor clear of oil, scrap, and other debris.

16. MAINTAIN TOOLS PROPERLY. ALWAYS keep tools clean and in good working order. Follow instruc-

tions for lubricating and changing accessories.

17. CHECK FOR DAMAGED PARTS. Check for alignment of moving parts, jamming, breakage, improper

mounting, or any other conditions that may affect the tool’s operation. Any part that is damaged should be properly

repaired or replaced before use.

18. MAKE THE WORKSHOP CHILDPROOF. Use padlocks and master switches and ALWAYS remove safety

keys.

19. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your

ability to properly use the tool.

20. USE SAFETY GOGGLES AT ALL TIMES that comply with ANSI Z87.1. Normal safety glasses only have

impact resistant lenses and are not designed for safety. Wear a face or dust mask when working in a dusty environ-

ment. Use ear protection such as plugs or muffs during extended periods of operation.

GENERAL SAFETY RULES

1. Ensure that the lighting is adequate.

2. Do not use the saw unless the guards are in place.

3. Do not use the saw to cut metal or masonry.

4. Keep the area free of tripping hazards.

5. Do not let anyone under 18 years operate this saw.

6. Always stand to one side when operating saw.

7. Never use damaged or deformed saw blades. Only use sharp blades.

8. When cutting round wood, use clamps that prevent the workpiece from turning on both sides of the blade.

9. Never use your to remove sawdust, chips or waste from near the saw blade.

10. Only use blades as recommended by the manufacturer.

11. Do not use blades manufactured from high-speed steel.

12. If the table insert is damaged or worn, have it replaced by an authorized service center.

SPECIFIC RULES FOR MITER SAWS

1 2 3 4 5 6 7 8 9 ... 19 20

No comments

Wen 70712 Use and Care Manual Page 4