Wen 4276 Use and Care Manual download pdf (Page 9)

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS

This bench grinder requires a minimal amount of assembly:

1. Remove parts from all of the cartons and lay them on a clean work surface.

2. Remove any protective materials and coatings from the bench grinder and its parts. The protective

coatings can be removed by spraying on WD-40 and wiping it off with a soft cloth. This may need to be

redone several times before all of the protective coatings are removed completely.

CAUTION: Do not use acetone, gasoline or lacquer thinner to remove any protective coatings.

3. Compare the items below; verify that all items are accounted for before discarding the shipping box. If

there are any missing parts, call our customer helpline at 1-800-232-1195 (Mon.-Fri. 8AM-5PM CST).

WARNING: If any parts are missing, do not attempt to plug in the power cord and turn on the

Bench Grinder. The Bench Grinder can only be turned on after all the parts have been obtained

and installed correctly.

The following items are to be provided in the shipping box:

1. Eye Shield Assembly (2)

2. Eye Shield Bracket (2)

3. Locking Knob M5 (2)

4. Tool Rest (2)

5. Lock Washer 6 (2)

6. Flat Washer 6 (2)

7. Carriage Head Screw M6x14 (2)

8. Tool Rest Knob M6 (2)

9. Hex Head Bolt M6x30 (2)

10. Spark Deflector (2)

11. Screw, Flat Washer and Spring Washer Kit (2)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Wen 4276 Use and Care Manual Page 9