10 Components of a Rotary Tool Collet Nut Housing Cap Brush Cap On/Off Switch Hanger Speed Dial Shaft Lock Button Flex Shaft
11 Assembly Warning: Always unplug Rotary Tool before changing accessories, changing collets or servicing your Rotary Tool. Collet nut To loosen,
12 The cable will become loose from the jacket and will uncontrollably whip or lash around. 1. Turn the tool off. 2. Remove the housing cap from
13 Operating Instructions ON/OFF switch 1. The on/off switch is located on the underside of the handle. It has two setting “0” (Off) and “I” (On).
14 increase the speed until you observe that the plastic is melting at the point of contact. Then reduce the speed slightly to get the optimum work
15 Ventilation openings and switch levers must be kept clean and free of foreign matter. Do not attempt to clean by inserting pointed objects throu
16 One (1) Year Limited Warranty WEN® is committed to building tools that are dependable for years. Our warranties are consistent with our commitm
2 Table of Contents Specifications………………………………………………………. 3 General Power Tool Safety Warnings……………………………… 4 Safety Rules for Rotary Tools…………………
3 Specifications Model: 2305 Rating: 120V, 60Hz, AC only Input: 1.0 Amp No Load Speed: 8,000-30,000 RPM Collet Size: Supplied with
4 General Power Tool Safety Warnings Read all safety warnings and all instructions. Failure to follow the warnings and instructions may result in e
5 Do not overreach. Keep proper footing and balance at all times. This enables better control of the power tool in unexpected situations. Dress pro
6 If cutting into existing walls or other blind areas where electrical wiring may exist is unavoidable, disconnect all fuses or circuit breakers fe
7 The direction of feed with the bit into the material when carving, routing or cutting is very important. Always feed the bit into the material in
8 Develop a periodic maintenance schedule for your tool. When cleaning a tool be careful not to disassemble any portion of the tool since internal
9 Protect your extension cords from sharp objects, excessive heat and damp or wet areas. Use a separate electrical circuit for your tools. This
Comments to this Manuals